How To Replace A Chrysler Pacifica Blower Motor Resistor

This page has free videos, resources, e-books and more dedicated to Blower Motor Resistor and How To Replace A Chrysler Pacifica Blower Motor Resistor!
WE ALSO HAVE THESE FREE BLOWER MOTOR RESISTOR GUIDES AVAILABLE




Posted on

Mute the speaker Listen to this using a male or female voice M/F 

By Christian Killian

Replacing the blower motor resistor pack may be necessary if the blower motor in your Pacifica is not working correctly. Most often, the blower will run on high and turn off but not function on any of the settings in between when the resistor is bad. A replacement resistor pack is available from most auto parts stores and is located on the face of the blower motor, where it meets the HVAC duct under the dash.

Mute the speaker Listen to this using a male or female voice M/F Open the hood of your Pacifica and locate the negative battery terminal at the battery. Loosen the pinch bolt on the cable end with a wrench then remove the cable from the terminal, isolating the cable while you work.

Mute the speaker Listen to this using a male or female voice M/F Open the passenger's door and locate the blower motor under the dash on the passenger's side. The motor sits directly behind the glove compartment.

Mute the speaker Listen to this using a male or female voice M/F Find the resistor pack on the face of the blower motor then remove the wiring harness connector by releasing the locking tab on the connector and pulling the connector straight off the resistor pack.

Mute the speaker Listen to this using a male or female voice M/F Locate the two retaining bolts on the ends of the resistor pack and remove them with a socket and ratchet. Slide the resistor out of the HVAC duct then lower it from behind the dash.

Mute the speaker Listen to this using a male or female voice M/F Position the new resistor pack in the HVAC duct then install the two retaining bolts and tighten them with a socket and ratchet. Do not over-tighten the bolts or you will damage the plastic housing.

Mute the speaker Listen to this using a male or female voice M/F Push the wiring harness connection onto the new resistor pack, making sure it is secure. Take your time to be sure it goes on straight or the pins can bend on the resistor pack, causing it to function incorrectly.

Mute the speaker Listen to this using a male or female voice M/F Move to the battery and install the negative battery cable on the negative battery terminal then tighten the pinch bolt with a wrench. Test the repair by running the blower through the speeds and verify it is working properly.

Share on Facebook Share on Twitter Email Gmail Yahoo! More...



Our Most Popular Article




More Blower Motor Resistor Information

 Ac Heater System
FREE E-Book
 Hvac Manual Bayhas
FREE E-Book
 501 Baldor
FREE E-Book
 Vehicle Guide
FREE E-Book
 Just The Facts Bwd
FREE E-Book
 Description
FREE E-Book
 Wiring Schematic
FREE E-Book
 6 Body Ken Gilbert
FREE E-Book
 Cor39iair Heater
FREE E-Book
 24 Jeep Club
FREE E-Book
 Hummer H3 Hvac
FREE E-Book
 Bus Products
FREE E-Book
 Heater Mellensnet
FREE E-Book
x